Performance Counter Usage

Install Counters

Refer to Performance Counters to see how the performance counters should be installed.

Enabling Counters For The Endpoint

Both the SLA and Critical Time counters are enabled and configured in code.

var performanceCounters = endpointConfiguration.EnableWindowsPerformanceCounters();
performanceCounters.EnableSLAPerformanceCounters(TimeSpan.FromSeconds(100));

The other counters are enabled by default.

The Handler

The handler has a random delay in achieving some fake load. The maximum random number is greater than the above-configured SLA value to cause SLA violations occasionally.

public class MyHandler : IHandleMessages<MyMessage>
{
    static ILog log = LogManager.GetLogger<MyHandler>();

    static Random random = new Random();

    public async Task Handle(MyMessage message, IMessageHandlerContext context)
    {
        var sleepTime = random.Next(1, 1000);
        await Task.Delay(sleepTime, context.CancellationToken);
        log.Info($"Hello from MyHandler. Slept for {sleepTime} ms");
    }
}

Run Solution

Run the solution so that the Performance Counter instances are registered.

Add Counters in Performance Monitor

1. Start Windows Performance Monitor.
2. Clear the default counters.
3. Add the NServiceBus Counters

Send Messages

Send any number of messages and watch the effect on the specific Performance Counters.

The sending code in Program.cs is set to send ten messages at a time.

Performance Counters Analysis

Critical Time

Continually sending more messages will cause the load on the endpoint to increase. This will eventually result in a back-logged queue. Messages will spend longer in the queue resulting in a gradual increase in Critical Time. Stop sending messages, and eventually, the endpoint will catch up, causing the Critical Time dropping back to zero.

SLA Violation Countdown

The SLA Violation Countdown is the number of seconds left until the SLA for the particular endpoint is breached, so effectively, this is an inverse counter. When messages are sent continually, the Critical Time will increase while the SLA Violation Countdown will decrease.

Other counters

To visualize both success and failures in the same view, change the handler code to the following.

var sleepTime = random.Next(1, 1000);
await Task.Delay(sleepTime, context.CancellationToken);
if (sleepTime % 2 != 0)
{
    throw new Exception();
}
log.Info($"Hello from MyHandler. Slept for {sleepTime} ms");

Run the endpoint and send some messages and monitor the results of all the performance counters.